Hyundai Equus Manuals

Hyundai Azera: Fender Garnish Repair procedures - Body Side Molding - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Fender Garnish Repair procedures

Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
•
Take care not to scratch the body surface.
1.
After loosening the mounting screws, then remove the fender garnish (A).

2.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
Roof Side Molding Repair procedures
Replacement [General Type]     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent da ...

Front Wheel Guard Repair procedures
Replacement     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

See also:

Blower Unit Components and Components Location
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Bl ...

Front Seat Belt Buckle Repair procedures
Replacement 1. Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly") 2. Disconnect the connector mounting clip (A). 3. After loosening the mounting bolt, then rem ...

Front Strut Assembly Repair procedures
Replacement 1. Remove the front wheel & tire (A). Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bolts ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com