Hyundai Equus Manuals

Hyundai Azera: Cowl Cross Bar Assembly Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Cowl Cross Bar Assembly Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Cowl Cross Bar Assembly Repair procedures

Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
•
Put on gloves to protect your hands.
1.
Remove the main crash pad assembly.
(Refer to Crash Pad - "Main Crash Pad Assembly")
2.
Remove the cowl top cover.
(Refer to "Cowl Top Cover")
3.
Disconnect the blower unit connectors.
4.
Disconnect the multi box connectors (A).
[Driver's]

[Passenger's]

5.
Disconnect the passenger compartment junction box connectors.

6.
Disconnect the airbag control module (SRSCM) connectors (A).

7.
Disconnect the connector (A) and the mounting clips in the front pillar.
[Driver's]

[Passenger's]

8.
After loosening the mounting bolts and nuts, then remove the cowl cross bar assembly (A).

9.
Installation is the reverse of removal.
   
•
Make sure the crash pad fits onto the guide pins correctly.
•
Before tightening the bolts, make sure the crash pad wire harnesses are not pinched.
•
Make sure the connectors are plugged in properly, and the antenna lead is connected properly.
•
Enter the anti- theft code for the radio, then enter the customer`s radio station presets.
Cowl Cross Bar Assembly Components and Components Location
Component Location 1. Cowl cross bar assembly ...

Roof Trim
...

See also:

Remote keyless entry system operations
Lock (1) 1. Carry the smart key. 2. Close all doors, engine hood and trunk. 3. Press the lock button(1). 4. All doors and trunk will lock. The hazard warning lights will blink and the chime w ...

ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle ...

Front Disc Brake Components and Components Location
Components 1. Guide rod bolt2. Bleed screw3. Caliper carrier4. Caliper body5. Inner pad shim6. Brake pad7. Pad retainer ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com