Hyundai Azera: Hazard warning flasher

The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible.
The hazard warning lights are turned on by pushing in the hazard switch. This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not in the ignition switch.
To turn the hazard warning lights off, push the switch a second time.
Rearview camera (If equipped)
LightingMain Muffler Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
(Refer to Engine Electrical System - "Battery")
2.
Remove the main muffler (A).
Tightening torque:
39.2 ~ 58.8 N.m ( ...
Hazard Lamp Switch Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the center console upper assembly (A) with hazard lamp switch.
Apply the protective tapes to the center ...
Components and Components Location
Component Location
1. Slide motor2. Front height motor3. Rear height motor4. Lumbar support motor5. Recline motor6. Cushion extension motor7. Lumbar support switch
...