1. Turn off the engine.
2. Loosen the retaining screws with a philips head screwdriver.
3. Remove the bulb assembly by turning it counterclockwise.
4. Remove the bulb by pulling it straight out.
5. Install a new bulb.
6. Reinstall the bulb assembly securely with the retaining screws.
ETC (Electronic Throttle Control) System Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle ...
Fluid Repair procedures
Service Adjustment Procedure
Oil level Check
A check of Automatic Transaxle Fluid(ATF) level is not
normally required during scheduled services. If an oil leak is found, ...
Heated Steering wheel Description and Operation
Description
The grip is heated as painting heat paint on steering grip for driver convenience for winter
Heated control unit
Heated pad
Specifications
ItemSpecificationVoltage13.5 VHeated ...