Hyundai Azera: Oil Pressure Switch Repair procedures
| Removal and Installation |
| 1. |
Remove the water pipe.
(Refer to Cooling System - "Water Pipe") |
| 2. |
Remove the oil pressure switch (A).
|
| 3. |
Installation is in the reverse order of removal. |
| Inspection |
| 1. |
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when
the fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch.
|
| 3. |
If there is no continuity when a 50 kpa (7psi) is applied
through the oil hole the switch is operaing properly. Check for air
leakage. If air leaks, the diaphragm is broken. Replace it. |
Oil Pressure Switch Components and Components Location
Oil Level Gauge & Pipe Components and Components LocationPower Mosfet Repair procedures
Inspection
1.
Ignition "ON"
2.
Manually operate the control switch and measure the voltage of blower motor.
3.
Select the control switch to raise voltage until high speed.
1. Drain2. Dr ...
Battery Sensor Description and Operation
Description
Vehicles have many control units that use more electricity.
These units control their own system based on information from diverse
sensors. It is important to have a stable power su ...
Closing the trunk
To close, lower the trunk lid, then press down on it until it locks. To be sure
the trunk lid is securely fastened, always check by trying to pull it up again.
Once the trunk is opened and then clos ...