Hyundai Azera: Armed stage
Park the vehicle and stop the engine. Arm the system as described below.
1.Turn off the engine.
2.Make sure that all doors, the engine hood and trunk lid are closed and latched.
3.Lock the doors by pressing the switch of the front outside door handle with the
smart key in your possession.
After completion of the steps above, the hazard warning lights operate once to indicate that the system is armed.
If any door remains opened, the doors will not lock and the chime will sound for 3 seconds. Close the door and try again to lock the doors.
If trunk lid or engine hood remains opened, the hazard warning lights will not operate and theft-alarm will not arm. After the trunk lid and engine hood are closed, the hazard warning lights will blink once.
Lock the doors by pressing the lock button on the smart key or with the mechanical key. After completion of the steps above, the hazard warning lights will operate once to indicate that the system is armed.
If any door, trunk lid or engine hood remains opened, the hazard warning lights will not operate and theft-alarm will not arm. After the doors, trunk lid and engine hood are closed, the hazard warning lights will blink once.
Do not arm the system until all passengers have left the vehicle. If the system is armed while a passenger( s) remains in the vehicle, the alarm may be activated when the remaining passenger(s) leave the vehicle. If any door, trunk lid or engine hood is opened within 30 seconds after entering the armed stage, the system is disarmed to prevent unnecessary alarm.
Theft-alarm system (If equipped)
Theft-alarm stageSpeakers Repair procedures
Inspection
1.
Troubleshooting for Speaker
(1)
Basic inspection of speaker
Inspect the sound from speaker after verifying that the
speaker mounting screws are removed and the wiring connector ...
CVVT (Continuously Variable Valve Timing) System Description and Operation
Description
Continuous Variable Valve Timing (CVVT) system advances or
retards the valve timing of the intake and exhaust valve in accordance
with the ECM control signal which is calculated by ...
Front Hub - Axle Repair procedures
Replacement
1.
Loosen the wheel lug nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire(A) from front hub.
Tightening torque:
88.2 ...