Hyundai Azera: Starter Relay Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Electrical System / Starting System / Starter Relay Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Electrical System / Starting System / Starter Relay Repair procedures
| Inspection |
| 1. |
Remove the fuse box cover. |
| 2. |
Remove the starter relay (A).
|
| 3. |
Using an ohmmeter, check that there is continuity between each terminal.
|
| 4. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
|
| 5. |
If there is no continuity, replace the starter relay. |
| 6. |
Install the starter relay. |
| 7. |
Install the fuse box cover. |
Starter Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the engine room under cover.
3.
Remove the starter cover (A).
Tightening torque :
Bolts: 8.8 ~ 13.7 N. ...
See also:
Components and Components Location
Component Location
1. Driver power window switch2. Door lock switch3. IPM(Intelligent intergrated Platform Module)4. Front door lock actuator5. Rear door lock actuator6. Trunk lid open actuator7. ...
Seat Heater Schematic Diagrams
Circuit Diagram
...
In-car sensor Description and Operation
Description
1.
In-car air temperature sensor is located at the lower crash pad.
2.
The sensor contains a thermistor which measures the
temperature of the cabin. The signal, determined by the ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com