Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and
detects the piston position of each cylinder which the CKPS can't
detect.
The two CMPS are installed on engine head cover of bank 1 and
2 respectively and uses a target wheel installed on the camshaft. The
Cam Position sensor is a hall-effect type sensor. As the target wheel
passes the Hall sensor, the magnetic field changes in the sensor. The
sensor then switches a signal which creates a square wave.
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...
Specification
ItemSpecificationOutput Voltage (V)High: 5.0VLow: 0.7VAir Gap (mm)0.5 ~ 1.5
...
See also:
Components and Components Location
Components
1. Front seat belt pretensioner2. Height adjuster3. Rear seat belt [RH]4. Rear seat belt [Center]5. Rear seat belt [LH]6. Rear seat belt buckle [LH]
...
Crash Pad Lower Panel Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Take ...
Drive belts
Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation
and replace if necessary. ...