Hyundai Azera: Rail Pressure Sensor (RPS) Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation
| Description |
Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in the sensor converts the
pressure to voltage signal. By using this signal, the ECM can control
correct injection amount and timing and adjusts the fuel pressure with
the fuel pressure regulator valve if the target pressure and the actual
pressure calculated by the RPS output signal are different.
Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Rail Pressure Sensor (RPS) Specifications
Specification
...
See also:
Heater Hose Components and Components Location
Components
1. Heater hose (Inlet)2. Heater hose (Outlet)3. Clamp
...
Ambient Sensor Description and Operation
Description
1.
The ambient temperature sensor is located at the front of the
condenser and detects ambient air temperature. It is a negative type
thermistor resistance will increase with lower ...
Components and Components Location
Components
1. Front pillar trim2. Center pillar upper trim3. Rear pillar trim4. Cowl side trim5. Center pillar lower trim6. Front door scuff trim7. Rear door scuff trim
...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com