Hyundai Equus Manuals

Hyundai Azera: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Removal
   
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
35R Clutch Control Solenoid Valve(35R/C_VFS) Schematic Diagrams
Circuit Diagram ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description and Operation
Description Underdrive brake control solenoid valve(UD/B) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the underdrive brake. ...

See also:

Side impact air bag
Your vehicle is equipped with a side impact air bag in each front and outboard rear seat. The purpose of the air bag is to provide occupants with additional protection than that offered by the sea ...

Repair procedures
Replacement [Removal]     • Put on gloves to protect your hands. • Use seat covers to avoid damaging any surfaces. 1. Remove the roof side molding. (Refer to ...

Engine overheat
If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1. Pull off the road ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com