Hyundai Azera: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the solenoid valve connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Schematic Diagrams
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description and OperationBattery
...
Air bag warning label
Air bag warning labels, some required by the U.S. National Highway Traffic Safety
Administration (NHTSA), are attached to alert the driver and passengers of potential
risks of the air bag system ...
Brake fluid
Check brake fluid level in the brake fluid reservoir. The level should be between
“MIN� and “MAX� marks on the side of the reservoir. Use only hydraulic brake fluid
conforming to DOT 3 or DO ...