Hyundai Azera: SS-A Solenoid Valve(ON/OFF) Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the solenoid valve connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification.
|
| Removal |
| 1. |
Remove the battery and the battery tray.
|
| 2. |
Remove the under cover (A).
|
| 3. |
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid") |
| 4. |
Remove the valve body cover (B) and eyebolt (A).
|
| 5. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector (A) and the oil temperature sensor connector (B).
|
| 6. |
Remove the solenoid valve (B) after removing the solenoid support (A).
|
| Installation |
| 1. |
Installation is the reverse of removal. |
|
SS-A Solenoid Valve(ON/OFF) Schematic Diagrams
SS-B Solenoid Valve(ON/OFF) Description and OperationOil Pan Repair procedures
Removal
[Lower oil pan]
1.
Drain the engine oil.
(Refer to Lubrication System - "Engine Oil")
2.
Remove the front muffler.
(Refer to Intake And Exhaust System - "Front Muffler")
3.
...
Roof antenna Components and Components Location
Components
...
Check battery and cables
Winter puts additional burdens on the battery system. Visually inspect the battery
and cables as described in section 7. The level of charge in your battery can be
checked by an authorized HYUNDAI d ...