Hyundai Equus Manuals

Hyundai Azera: BJ Boot Repair procedures - Driveshaft Assembly - Driveshaft and axle - Hyundai Azera 2011-2026 Service ManualHyundai Azera: BJ Boot Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Repair procedures

Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
Remove the dynamic damper.
(Refer to Driveshaft Assembly - "Dynamic Damper")
4.
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.
Remove the BJ boot.
6.
Install in the reverse order of removal.
   
•
Do not disassemble the BJ assembly.
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new one.
BJ Boot Components and Components Location
Components [LH] 1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circl ...

Rear Axle Assembly
...

See also:

Rear Door Curtain Assembly Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. After loosening the mounting screws, then remove the rear door curtain (A). 3. Installation is the re ...

General Safety Information and Caution
Smart Cruise Control Be careful when driving the vehicle using the smart cruise control system as follows.     • The smart cruise control system may have limits to detect di ...

Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams
Circuit Diagram ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com