Hyundai Equus Manuals

Hyundai Azera: Hands Free Switch Repair procedures - Hands Free System - Body Electrical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Hands Free Switch Repair procedures

Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the steering wheel.
3.
Remove the cover (A) after loosening screws.

4.
Disconnect the upper and lower steering wheel remote control switch connector (A) in the left.

5.
Remove the steering wheel remote control switch assembly (A) after loosening screws.

Installation
1.
Install the hands free switch to the steering wheel.
2.
Install the steering wheel.
3.
Reassemble the driver airbag module.
   
Make sure the hands free remote control switch and the airbag module connectors are plugged in properly.
Inspection
1.
Check BCM input/output specification of SWRC using the GDS.
Hands Free Switch Schematic Diagrams
Circuit Diagram ...

Hands Free Mic Repair procedures
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to Body - "Roof Trim Assembly") 3. Remove the handsfree mic (A) after disconnect the connector f ...

See also:

Engine Hanger Repair procedures
Removal and Installation [Front engine hanger] 1. Remove the front engine hanger (A) Tightening torque: 44.1 ~ 53.6N.m (4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft) 2. Install in the reverse ord ...

Drive belts
Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation and replace if necessary. ...

Wheel Repair procedures
Lug nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     When using an impact gun, final tigh ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com