Hyundai Azera: Inhibitor Switch Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Description and Operation
| Description |
Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals.
SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valver connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Inhibitor Switch Specifications
Specifications
? Type: Combination of output signals from 4 terminals
Power supply (V)12Output typeCombination of output signals
Signal Code Table
PP-RRR-NNN-DDSignal 112V12V00000Signal 20 ...
See also:
Drive Belt Tensioner Repair procedures
Removal and Installation
1.
Remove the drive belt idler.
(Refer to Timing System - "Idler")
2.
Remove the drive belt auto tensioner (A).
Tightening torque
Bolt (B) :
81.4 ~ 85.3N.m (8.3 ...
Vehicle weight
This section will guide you in the proper loading of your vehicle, to keep your
loaded vehicle weight within its design rating capability. Properly loading your
vehicle will provide maximum return o ...
Description and Operation
Refrigeration Cycle
Air Outlet and Air Flow
The mode selection switch controls the direction of the air flow through the ventilation
System
Air FlowSymbolOutletDescriptionVentB,C,D,E,FAir f ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com