Hyundai Equus Manuals

Hyundai Azera: Knock Sensor (KS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Knock Sensor (KS) Repair procedures

Removal
[Knock Sensor #1 (Bank 1)]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the knock sensor connector (A).

3.
Remove the intake manifold.
4.
Remove the installation bolt (A), and then remove the sensor from the cylinder block.

[Knock Sensor #2 (Bank 2)]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the knock sensor connector (A).

3.
Remove the intake manifold.
4.
Remove the installation bolt (A), and then remove the sensor from the cylinder block.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
   
•
The sensor connector must be installed parallel to the direction of the engine.
1.
Installation is reverse of removal.

Knock sensor installation bolt:
15.7 ~ 23.5 N.m (1.6 ~ 2.4 kgf.m, 11.6 ~ 17.4 lb-ft)

Knock Sensor (KS) Schematic Diagrams
Circuit Diagram ...

Heated Oxygen Sensor (HO2S) Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of the zirconium and the alumina and is installed on upstream and downstream of the Warm-up Catalytic Converter (WCC). After it compares oxygen ...

See also:

Seat Belt Pretensioner (BPT) Description and Operation
Description The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps ...

Description and Operation
Description The hydraulic system consists of oil, an oil filter, an oil pump, and a valve body (valves and solenoid valves). The oil pump is powered by the engine. ATF passes through the oil fi ...

GAWR (Gross axle weight rating)
This is the maximum allowable weight that can be carried by a single axle (front or rear). These numbers are shown on the certification label. The total load on each axle must never exceed its GAWR. ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com