Hyundai Azera: Line Pressure Control Solenoid Valve Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the solenoid valve connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
Line Pressure Control Solenoid Valve Schematic Diagrams
35R Clutch Control Solenoid Valve(35R/C_VFS) Description and OperationFront Wheel Speed Sensor Components and Components Location
Components
1. Front wheel speed sensor2. Front wheel speed sensor connector
...
Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat
belts. The purpose of the pretensioner is to make sure that the seat belts fit tightly
against the occupan ...
Passive Occupant Detection System (PODS-F) Repair procedures
Removal
PODS-F ECU
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front passenger seat assembly.
(Refer to Body - "Front s ...