Hyundai Equus Manuals

Hyundai Azera: Master Cylinder Repair procedures - Brake System - Brake System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Master Cylinder Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Brake System / Brake System / Master Cylinder Repair procedures

Removal
1.
Turm ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the air duct (B) and air cleaner assembly (A).

3.
Disconnect the brake fluid level switch connector (B), and remove the reservoir cap.

4.
Remove the brake fluid from the master cylinder reservoir with a syringe.
   
•
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
5.
Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.
Tightening torque:
18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

6.
Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).
Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

Installation
1.
Installation is the reverse of removal.
2.
After installation, bleed the brake system.
(Refer to Brake system bleeding)
Master Cylinder Components and Components Location
Components 1. Reservoir cap2. Reservoir3. Grommet4. Master cylinder ...

Brake Line Components and Components Location
Components ...

See also:

Schematic Diagrams
System Block Diagram ...

Components and Components Location
Component Location (1) 1. Buzzer2. RF receiver3. Smart key unit4. Interior antenna 15. Interior antenna 26. Trunk antenna7. Bumper antenna Component Location (2) 1. Start Stop Button (SSB)2 ...

Repair procedures
On-vehicle Inspection     • Check that the battery cables are connected to the correct terminals. • Disconnect the battery cables when the battery is given a quick ch ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com