Hyundai Equus Manuals

Hyundai Azera: Rear Back Armrest Cup Holder Repair procedures - Rear Seat - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Back Armrest Cup Holder Repair procedures

Replacement
   
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
•
Put on gloves to protect your hands.
1.
Remove the rear back armrest.
(Refer to Rear Seat - "Rear Back Armrest")
2.
Using a screwdriver or remover, remove the rear seat back armrest inner cover (A).

3.
Disconnect the connector (A).

4.
Using a screwdriver or remover, remove the rear seat armrest remote controll (A).

5.
Disconnect the connectors (A).

6.
After loosening the mounting screws, then remove the rear back armrest cup holder (A).

7.
Installation is the reverse of removal.
   
•
Make sure the connectors are plugged in properly.
•
Replace any damage clips.
Rear Back Armrest Cup Holder Components and Components Location
Component Location 1. Rear back armrest cup holder ...

Front Seat Belt
...

See also:

To keep locks from freezing
To keep the locks from freezing, squirt an approved de-icer fluid or glycerine into the key opening. If a lock is covered with ice, squirt it with an approved de-icing fluid to remove the ice. If th ...

Line Pressure Control Solenoid Valve Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Schematic Diagrams
Circuit Diagram ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com