Hyundai Azera: Smart key antenna Repair procedures
| Removal |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the main crash pad.
|
| 3. |
Remove the interior 1 antenna (A) after disconnecting the connector and loosening the mounting nuts (2EA).
|
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the center console.
|
| 3. |
Remove the interior 1 antenna (A) after loosening the mounting nuts (2EA).
|
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the trunk transverse trim.
|
| 3. |
Disconnect the trunk antenna connector (A) and remove the trunk antenna (B) after loosening screws (2EA).
|
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the rear bumper.
|
| 3. |
Disconnect the exterior bumper antenna connector on rear bumper center part. |
| 4. |
Disconnect the antenna connector and remove the exterior bumper antenna (A) after loosening the screws (2EA).
|
| Installation |
| 1. |
Install the interior 1 antenna. |
| 2. |
Install the main crash pad. |
| 3. |
Install the negative (-) battery terminal and check the smart key system. |
| 1. |
Install the interior 2 antenna. |
| 2. |
Install the center console. |
| 3. |
Install the negative (-) battery terminal and check the smart key system. |
| 1. |
Install the trunk antenna. |
| 2. |
Install the trunk tranverse trim. |
| 3. |
Install the negative (-) battery terminal and check the smart key system. |
| 1. |
Install the exterior bumper antenna. |
| 2. |
Install the rear bumper. |
| 3. |
Install the negative (-) battery terminal and check the smart key system. |
Smart key antenna Specifications
Smart key receiver SpecificationsCarry emergency equipment
Depending on the severity of the weather where you drive your vehicle, you should
carry appropriate emergency equipment. Some of the items you may want to carry include
tire chains, tow straps or ch ...
CVVT Oil Temperature Sensor (OTS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OTS connector.
3.
Remove the OTS. (Refer to "Removal")
4.
After immersing the thermistor of the sensor into engine coolant ...
Inhibitor Switch Description and Operation
Description
Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...