Hyundai Azera: Troubleshooting
| Troubleshooting |
| Trouble Symptom | Probable cause | Remedy |
| Vehicle pulls to one side | Scoring of driveshaft ball joint | Replace |
| Wear, rattle or scoring of wheel bearing | Replace | |
| Tire conicity (rotate tires, replace if necessary) | Replace | |
| Check alignment | Replace | |
| Tire pressure | Replace | |
| Test on a flat road | Replace | |
| Defective front suspension and steering | Adjustment or Replace | |
| Vibration | Wear, damage or bending of driveshaft | Replace |
| Driveshaft rattle and hub serration | Replace | |
| Wear, rattle or scratching of wheel bearing | Replace | |
| Shimmy | Defective wheel balance | Adjustment or Replace |
| Defective front suspension and steering | Adjustment or Replace | |
| Excessive noise | Wear, damage or bending of driveshaft | Replace |
| Rattle of driveshaft and worn hub splines | Replace | |
| Wear, rattle or scoring of wheel bearing | Replace | |
| Loose hub nut | Adjustment or Replace | |
| Defective front suspension and steering | Adjustment or Replace |
Special Service Tools
Special Tools
Tool(Number and Name)IllustrationUse09495-3K000Band installerInstallation of ear type boot band09495-33000PullerRemove the spider assembly from the driveshaft
...
See also:
Repair procedures
Replacement
[Removal]
•
Put on gloves to protect your hands.
•
Use seat covers to avoid damaging any surfaces.
1.
Remove the front pillar trim.
(Refer to ...
Rearview camera (If equipped)
The rearview camera will activate when the back-up light is ON with the ignition
switch ON and the shift lever in the R (Reverse) position.
This system is a supplemental system that shows behind t ...
Hood Lift Repair procedures
Replacement
1.
Using a screwdriver (A), lift the socket clips (B) up
slightly on both ends of the lifter (C), and then remove the lifter from
the bracket (D).
2.
Installation is the revers ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com