Hyundai Azera: Variable Intake Solenoid (VIS) Valve Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Description and Operation
| Description |
Variable Intake manifold Solenoid (VIS) valves are installed
on the intake manifold (VIS Valve 1) and the surge tank (VIS Valve 2).
These VIS valve 1 and 2 control vacuum modulators which activate valves
in the intake manifold and the surge tank. These valves are opened or
closed by ECM according to engine condition (Refer to below table).
CVVT Oil Control Valve (OCV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specifi ...
Variable Intake Solenoid (VIS) Valve Specifications
Specification
ItemSpecificationCoil Resistance (?)30.0 ~ 35.0 [20°C(68°F)]
...
See also:
Immobilizer Control Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Disconnect the connector of the immobilizer unit ...
Steering Angle Sensor Description and Operation
Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor
Driven Power Steering) and it sends messages to HECU through CAN
communication line.
The SAS is used to determine turnin ...
Rear Door Outside Handle Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the hole plug (B).
3.
After loosening the mounting bolt, then remove the rear door outside hand ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com