Hyundai Equus Manuals

Hyundai Azera: Center Fascia Panel Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Center Fascia Panel Repair procedures

Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the center facia side garnish (A).

2.
Remove the gear boots (B) and gear knob (A).

3.
Using a screwdriver or remover, remove the console upper tray complete (A).

4.
Disconnect the connectors (A).

5.
After loosening the mounting screws, then remove the cup holder tray (A).

6.
After loosening the mounting screws, then remove the center fascia tray (A).

7.
Disconnect the connectors (A).

8.
Using a screwdriver or remover, remove the center facia panel (A).

9.
Disconnect the connectors (A).

10.
Installation is the reverse of removal.
   
•
Make sure the connector are connected in properly.
•
Replace any damage clips.
Center Fascia Panel Components and Components Location
Component Location 1. Center fascia panel ...

Crash Pad Lower Panel Components and Components Location
Component Location 1. Crash pad lower panel ...

See also:

Front Disc Brake Components and Components Location
Components 1. Guide rod bolt2. Bleed screw3. Caliper carrier4. Caliper body5. Inner pad shim6. Brake pad7. Pad retainer ...

Hood Insulator Pad Repair procedures
Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A).     • Be careful not to scratch the hood panel. 2. Installation is th ...

Tire terminology and definitions
Air Pressure: The amount of air inside the tire pressing outward on the tire. Air pressure is expressed in pounds per square inch (psi) or kilopascal (kPa). Accessory Weight: This means the comb ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com