Hyundai Equus Manuals

Hyundai Azera: Description and Operation - Front Back view camera System - Body Electrical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Description and Operation

Description
Front blind camera is a supplemental system that shows blind spot in front of the vehicle through the AV monitor.
The front blind camera will operate when you push the button and shift the transaxle into N(Neutral) or D(Drive) while driving less then 10km/h. After the vehicle stops for 4 minutes with the transaxle in N(Neutral) or D(Drive), it will bring up the previous screen.
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the REVERSE position.
This system is a supplemental system that shows behind the vehicle through the AV monitor while backing-up.
   
This system is a supplementary function only. It is the responsibility of the driver to always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there may be blind spot that can't be seen by the camera.
Schematic Diagrams
Circuit Diagram ...

Repair procedures
Removal Front View Camera 1. Remove the front bumper. (Refer to Body - "Front Bumper Cover") 2. Loosen 3 screws and disconnect the connector(6 pins). Remove the front view camera(A). Back ...

See also:

TPMS Receiver Description and Operation
Description 1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state. B. In this state, there is no Auto-L ...

Schematic Diagrams
Circuit Diagram ...

Rear Disc Brake Repair procedures
Removal 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Loosen the bolt & nut and then disconnect the shock absorbe ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com