Hyundai Azera: Erasing HomeLink® buttons
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Owners Manual / Features of your vehicle / Mirrors / Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash after 10 seconds.
2. Release both buttons. Do not hold for longer than 20 seconds.
The Integrated HomeLink® Wireless Control System is now in the training (learn) mode and can be programmed at any time following the appropriate steps in the Programming sections above.
FCC ID: NZLTLMHL4 IC: 4112A-TLMHL4
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
WARNING
The transceiver has been tested and complies with FCC and Industry Canada rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.
NVS® is a registered trademark and Z-Nav™ is a trademark of the Gentex Corporation, Zeeland, Michigan. HomeLink® is a registered trademark owned by Johnson Controls, Incorporated, Milwaukee, Wisconsin.
Reprogramming a single HomeLink® button
To program a device to HomeLink® using a HomeLink® button previously trained,
follow these steps:
1. Press and hold the desired HomeLink® button.DO NOT release the button.
2. The indicator light ...
Outside rearview mirror
Be sure to adjust mirror angles before driving.
Your vehicle is equipped with both left-hand and right-hand outside rearview
mirrors. The mirrors can be adjusted remotely with the remote switch. The ...
See also:
Repair procedures
Removal
Front View Camera
1.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
2.
Loosen 3 screws and disconnect the connector(6 pins). Remove the front view camera(A).
Back ...
Oil Filter Repair procedures
Replacement
1.
Remove the engine cover.
2.
Wait for 5 minutes after loosening the oil filter cap to drain well the oil in the oil filter.
3.
Replace the oil filter.
(1)
Disconnect the ...
CVVT Oil Control Valve (OCV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specifi ...
Categories
Hyundai Azera Manuals
