Hyundai Equus Manuals

Hyundai Azera: Front Door Module Repair procedures - Front Door - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Door Module Repair procedures

Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Handle")
3.
Loosen the mounting bolt (A).

4.
After loosening the front door module mounting bolts, then remove the front door module (A).

Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

5.
Disconnect the connectors and front door module wiring harness (A).

6.
Installation is the reverse of removal.
   
•
The area of whole parts should be applied with sufficient grease.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks/unlocks and opens/closes properly.
Front Door Module Components and Components Location
Component Location 1. Front door module ...

Front Door Outside Handle Components and Components Location
Component Location 1. Front door outside handle ...

See also:

To keep locks from freezing
To keep the locks from freezing, squirt an approved de-icer fluid or glycerine into the key opening. If a lock is covered with ice, squirt it with an approved de-icing fluid to remove the ice. If th ...

Inhibitor Switch Schematic Diagrams
Circuit Diagram ...

Engine Control Module (ECM) Repair procedures
Removal     When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1. Perform "ECM Neutr ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com