Hyundai Azera: Cluster Fascia Panel Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel Repair procedures
| Replacement |
|
| 1. |
Using a screwdriver or remover, remove the crash pad side cover (A).
|
| 2. |
Using a screwdriver or remover, remove the fuse box cover (A).
|
| 3. |
After loosening the mounting screws, then remove the crash pad lower panel (A).
|
| 4. |
Disconnect the diagnosis connector (A) and connector (B).
|
| 5. |
After loosening the mounting screws, then remove the crash pad garnish [LH] (A).
|
| 6. |
After loosening the mounting screws, then remove the cluster fascia panel (A).
|
| 7. |
Installation is the reverse of removal.
|
Cluster Fascia Panel Components and Components Location
Component Location
1. Cluster fascia panel
...
Center Fascia Panel Components and Components Location
Component Location
1. Center fascia panel
...
See also:
Using iPod® Mode
Playing/Pausing iPod® Songs
Once an iPod® is connected, the mode will automatically start and begin playing
an iPod® song.
While playing, press the key to
pause and press again to play.
...
Troubleshooting
Failure Diagnosis
1.
In principle, ESC and TCS controls are prohibited in case of ABS failure.
2.
When ESC or TCS fails, only the failed system control is prohibited.
3.
However, when the ...
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com