Hyundai Azera: Glove Box Housing Repair procedures

Fifth generation HG (2011â€“2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing Repair procedures

Replacement

â€¢	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

â€¢	Take care not to scratch the body surface.

â€¢	Put on gloves to protect your hands.

1.	Using a screwdriver or remover, remove the crash pad side cover (A).

2.	Disconnect the stopper (B) from the glove box (A).

3.	Disconnect the air damper (A) from the glove box (B).

4.	Disconnect the pin (A) and then remove the glove box (B).

5.	After loosening the mounting screws, then remove the passenger's under cover (A).

6.	Disconnect the connector (A).

7.	After loosening the mounting screws, then remove the glove box housing (A).

8.	Disconnect the connectors (A).

9.

Installation is the reverse of removal.

â€¢	Make sure the connector are connected in properly.

â€¢	Replace any damaged clips.

Glove Box Housing Components and Components Location

Component Location 1. Glove box housing ...

Steering Column Shroud Panel Components and Components Location

Component Location 1. Steering column shroud panel ...

See also:

Engine number
The engine number is stamped on the engine block as shown in the drawing. ...

Inhibitor Switch Repair procedures
Inspection â€¢ Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Inspection flow Items to ch ...

Rear Glass Defogger Printed Heater Repair procedures
Inspection Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on the tin foil, moving the tin foil along th ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com