Hyundai Equus Manuals

Hyundai Azera: Rear Bumper Cover Repair procedures - Rear Bumper - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Bumper Cover Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Cover Repair procedures

Replacement
   
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
•
Put on gloves to protect your hands.
1.
Remove the luggage side trim.
(Refer to "Trunk Trim")
2.
Disconnect the rear bumper main connector (A).

3.
Disconnect the connector (B), and then loosen the rear combination lamp mounting nuts.
4.
Remove the rear combination lamp (A).

5.
Remove the rear bumper lower mounting clips.

6.
Loosen the mounting bolts.

7.
After loosening the rear bumper side's mounting screws, then disconnect the side's.

8.
After loosening the mounting screw and clips, then remove the rear bumper cover (A).

9.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
•
Make sure the connector is plugged in properly.
Rear Bumper Cover Components and Components Location
Component Location 1. Rear Bumper Cover ...

Front Seat
...

See also:

Oil Filter Body Components and Components Location
Components 1. Oil filter body2. Gasket ...

TPMS Sensor Repair procedures
Removal 1. Remove the tire. (Refer to Tires/Wheels - "Tire") 2. Remove the valve nut.     The valve nut should not be re-used. Installation Sensor Fit   & ...

Compressor Components and Components Location
Components 1. Screw2. Bolt3. Limiter Assembly4. Retainer Ring5. Pulley6. Connector Bracket7. Compressor Assembly ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com