Hyundai Equus Manuals

Hyundai Azera: Rear Seat Assembly Repair procedures - Rear Seat - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Seat Assembly Repair procedures

Replacement
1.
After loosening the mounting bolts, then remove the rear seat cushion assembly (A).

Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)

2.
Disconnect the rear seat cushion heater connector (A).

3.
After loosening the mounting bolts, then remove the rear seat back assembly (A).

Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)

4.
Disconnect the rear seat back heater connector (A) and airbag connector (B).
[LH]

[RH]

5.
Installation is the reverse of removal.
   
•
Make sure the connector is plugged in properly.
Rear Seat Assembly Components and Components Location
Component Location 1. Rear seat cushion assembly2. Rear seat back assembly ...

Rear Seat Back Cover Components and Components Location
Component Location 1. Rear seat back cover ...

See also:

Master Cylinder Repair procedures
Removal 1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air duct (B) and air cleaner assembly (A). 3. Disconnect the brake fluid level switch conne ...

Transaxle Oil Temperature Sensor Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

MEDIA MODE
Pressing the key will change the operating mode in order of CD➟USB(iPod®)➟AUX➟My Music ➟ BT Audio. If [Mode Pop up] is turned on within [Display], then pressing t ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com