Hyundai Equus Manuals

Hyundai Azera: Rear Seat Belt Retractor Repair procedures - Rear Seat Belt - Body (Interior and Exterior) - Hyundai Azera 2011-2025 Service ManualHyundai Azera: Rear Seat Belt Retractor Repair procedures

Replacement
   
•
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear package tray trim.
(Refer to Interior Trim - "Rear Package Tray Trim")
2.
After loosening the rear seat belt retractor (B) mounting bolt, then remove the rear seat belt (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

[Center]

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
Rear Seat Belt Retractor Components and Components Location
Component Location 1. Rear seat belt retractor2. Rear center seat belt retractor ...

Rear Seat Belt Buckle Components and Components Location
Component Location 1. Rear seat belt buckle [LH]2. Rear seat belt buckle [RH] ...

See also:

Antenna Coil Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Disconnect the 6P connector (B) of the coil ante ...

High Pressure Fuel Pump Repair procedures
Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure f ...

Intake Actuator Description and Operation
Description 1. The intake actuator is located at the blower unit. 2. It regulates the intake door by signal from control unit. 3. Pressing the intake selection switch will shift between re ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com