Hyundai Azera: Parking Assist Sensor Repair procedures
| Removal |
| 1. |
Remove the front bumper.
|
| 2. |
Pull out the front sensor (A) from the sensor holder by opening the sensor holder out.
|
| 3. |
Disconnect the connector from the front sensor.
|
| 1. |
Remove the rear bumper.
|
| 2. |
Pull out the rear sensor (A) from the sensor holder by opening the sensor holder out.
|
| 3. |
Disconnect the connector from the rear sensor.
|
| Installation |
| 1. |
Install the parking assist sensor to the bumper. |
| 2. |
Connect the connector. |
| 3. |
Install the corresponding bumper. |
Parking Assist Sensor Schematic Diagrams
Front Rear Parking Assist System Switch Repair proceduresComponents and Components Location
Components
1. Rear door trim2. Rear door inside handle cap3. Rear door module4. Rear frame inner cover5. Rear door panel6. Rear door delta lower run & channel7. Rear door frame rear garnish8 ...
Input Speed Sensor Troubleshooting
Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Cylinder Block Components and Components Location
Components
1. Piston ring2. Piston3. Connecting rod4. Connecting rod upper bearing5. Piston pin6. Connecting rod lower bearing7. Connecting rod bearing cap8. Baffle plate9. Upper oil pan10. Cylin ...