Hyundai Equus Manuals

Hyundai Azera: Variable Intake Solenoid (VIS) Valve Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Variable Intake Solenoid (VIS) Valve Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between the VIS valve terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the variable intake solenoid valve connector (A).
3.
Disconnect the vacuum hoses (B, C) from the valve.
4.
Remove the installation nut (D), and then remove the valve.
[Vave 1 (Intake manifold)]

[Vave 2 (Surge tank)]

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Be careful of foreign material not to flow into the valve.
1.
Installation is reverse of removal.
Variable intake solenoid valve installation nut:
5.9 ~ 8.8 N.m (0.6 ~ 0.9 kgf.m, 4.3 ~ 6.5 lb-ft)
Variable Intake Solenoid (VIS) Valve Schematic Diagrams
Circuit Diagram ...

Fuel Pressure Control Valve (FPCV) Description and Operation
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on var ...

See also:

Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and wip ...

Theft-alarm stage
The alarm will be activated if any of the following occurs while the system is armed. A door is opened without using the smart key. A door is opened without using the mechanical key. The trun ...

Front Hub - Axle Repair procedures
Replacement 1. Loosen the wheel lug nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire(A) from front hub. Tightening torque: 88.2 ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com