Hyundai Equus Manuals

Hyundai Azera: Fuel Tank Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Fuel Tank Repair procedures

Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
2.
Remove the fuel pump service cover (A) in the trunk.

3.
Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
4.
Disconnect the fuel feed tube quick connector (C).

5.
Lift the vehicle and support the fuel tank with a jack.
6.
Remove the center muffler assembly.
7.
Disconnect the fuel filler hose (A).

8.
Disconnect the vapor hose quick-connector (A).

9.
Remove the parking brake line (A).

10.
Remove the fuel tank band installation nuts (A).

11.
Remove the fuel tank after removing the fuel tank band (A) as below.

Installation
1.
Installation is reverse of removal.

Fuel tank band installation nut:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

Repair procedures
Fuel Pressure Test 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)     When removing the fuel pum ...

Fuel Pump Repair procedures
Inspection [Fuel pump] 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump assembly. 3. Check motor operation by fuel pump connector (A) connecti ...

See also:

Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal     • DON'T remove the camshaft posit ...

Multimedia Jack Schematic Diagrams
Circuit Diagram ...

Hill-start assist control (HAC)
The main intent is to prevent the vehicle from rolling backwards while driving uphill on an inclined surface. HAC holds the braking pressure built up by the driver when the vehicle is stopped for 2 ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com