Description |
1. |
The intake actuator is located at the blower unit. |
2. |
It regulates the intake door by signal from control unit. |
3. |
Pressing the intake selection switch will shift between recirculation and fresh air modes. |
Water pump Troubleshooting
Troubleshooting
SymptomsPossible CausesRemedyCoolant leakage
•
From the bleed hole of the water pump
Visually check
•
Check leaks after about ten-minute warming up.
•
If coolant st ...
Front Oil Seal Repair procedures
Removal
1.
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley")
2.
Remove the front oil seal (A).
Installation
1.
Using SST(09231-3C100), install t ...
Rear Door Trim Components and Components Location
Component Location
1. Rear door trim
...