Hyundai Equus Manuals

Hyundai Azera: Intake Actuator Repair procedures - Blower - Heating,Ventilation, Air Conditioning - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Intake Actuator Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Intake Actuator Repair procedures

Inspection
1.
Ignition "OFF".
2.
Disconnect the intake actuator connector.
3.
Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grounding terminal 7.
4.
Verify that the intake actuator operates to the fresh position when connecting in the reverse.

1. -
2. -
3. Fresh
4. 5V (Vcc)
5. Feedback Signal
6. Sensor GND
7. Rec

5.
Check the voltage between terminals 5 and 6.
Specification
Door position
Voltage(5-6)
Error detecting
Recirculation
0.3 ± 0.15V
Low voltage :0.1V or less
Fresh
4.7 ± 0.15V
High voltage :4.9V or more

6.
If the intake actuator is not operated well, substitute with a known-good intake actuator and check for proper operation.
7.
If the problem is corrected, replace the intake actuator.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad.
3.
Disconnect the Intake actuator connector (A).
4.
Loosen the mounting screw and then remove the intake actuator (B).

5.
Installation is the reverse order of removal.
Intake Actuator Description and Operation
Description 1. The intake actuator is located at the blower unit. 2. It regulates the intake door by signal from control unit. 3. Pressing the intake selection switch will shift between re ...

Controller
...

See also:

Master Cylinder Repair procedures
Removal 1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air duct (B) and air cleaner assembly (A). 3. Disconnect the brake fluid level switch conne ...

Spark Plug Repair procedures
Removal and Installation 1. Remove the ignition coils. (Refer to Ignition System - "Ignition Coil") 2. Using a spark plug socket, remove the spark plug. Tightening torque : 14.7 ~ 24.5N. ...

Front Hub - Axle Repair procedures
Replacement 1. Loosen the wheel lug nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire(A) from front hub. Tightening torque: 88.2 ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com