Hyundai Equus Manuals

Hyundai Azera: Oil Pump Repair procedures - Lubrication System - Engine Mechanical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Oil Pump Repair procedures

Removal
1.
Remove the lower oil pan.
(Refer to Lubrication System - "Oil Pan")
2.
Remove the oil pump chain cover (A).

Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

3.
Remove the bolt (A) and then seperate the chain with sprocket from the oil pump.

Tightening torque :
18.6 ~ 21.6N.m (1.9 ~ 2.2kgf.m, 13.7 ~ 15.9lb-ft)

4.
Remove the oil pump (A).

Tightening torque :
20.6 ~ 22.6N.m (2.1 ~ 2.3kgf.m, 15.2 ~ 16.6lb-ft)

   
When installing, use a new O-ring.
5.
Install in the reverse order of removal.
Installation
1.
Install the oil pump (A).

Tightening torque :
20.6 ~ 22.6N.m (2.1 ~ 2.3kgf.m, 15.2 ~ 16.6lb-ft)

   
Always use a new O-ring.
2.
Install the oil pump sprocket and the oil pump chain on the oil pump, and tighten the sprocket bolt (A).

Tightening torque :
18.6 ~ 21.6N.m (1.9 ~ 2.2kgf.m, 13.7 ~ 15.9lb-ft)

3.
Install the oil pump chain cover (A).

Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

4.
Install the lower oil pan.
(Refer to Lubrication System - "Oil Pan")
5.
After assembly, wait at least 30 minutes before filling the engine with oil.
Oil Pump Components and Components Location
Components 1. Oil pump2. O-ring3. Oil pump sprocket4. Oil pump chain cover ...

Oil Pressure Switch Components and Components Location
Components 1. Oil cover2. Oil cover gasket3. Oil pressure switch ...

See also:

Smart key receiver Repair procedures
Removal RF Receiver     - Take care not to scratch the crash pad and related parts 1. Disconnect the negative(-) battery terminal. 2. Remove the rear seat. (Refer to ...

Injector Drive Box (IDB) Schematic Diagrams
IDB terminal and Inoutput IDB terminal function Connector [CLG02] Pin No.DescriptionConnected to1-?2-?3-?4-?5-?6-?7-?8-?9-?10-?11-?12-?13-?14-?15-?16Injector (Cylinder #3) [Low] control outputI ...

IMS (Integrated Memory System) module Repair procedures
Removal 1. Remove the negative (-) battery terminal. 2. Remove the driver seat in the car. (Refer to Body - "Front Seat Assembly") 3. Remove the IMS module (A) after loosening 3 screws in ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com