Replacement |
|
1. |
Using a screwdriver or remover, remove the rear pillar trim (A). |
2. |
Installation is the reverse of removal.
|
Barometric Pressure Sensor (BPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Turn ...
Repair procedures
Replacement
[Removal]
•
Put on gloves to protect your hands.
•
Use seat covers to avoid damaging any surfaces.
1.
Remove the roof side molding.
(Refer to Bod ...
Fuel filler lid
...