Hyundai Equus Manuals

Hyundai Azera: Steering Column Shroud Panel Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Steering Column Shroud Panel Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Steering Column Shroud Panel Repair procedures

Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
•
Put on gloves to protect your hands.
1.
After loosening the mounting screws, then remove the steering column shroud panel (A).

2.
Disconnect the connector (A).

3.
Installation is the reverse of removal.
   
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.
Steering Column Shroud Panel Components and Components Location
Component Location 1. Steering column shroud panel ...

Crash Pad Side Cover Components and Components Location
Component Location [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

See also:

Components and Components Location
Component Location 1. Start Stop Button(SSB)2. FOB key3. Smart key unit4. RF receiver5. Interior antenna 16. Interior antenna 2 7. Trunk antenna8. Door handle & ...

SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valver connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Hood Seal Weatherstrip Repair procedures
Replacement 1. Detach the clips, then remove the hood seal weatherstrip (A).     • Be careful not to scratch the hood seal weatherstrip. 2. Installation is the rev ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com