Hyundai Azera: Cluster Fascia Panel Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

•	Put on gloves to protect your hands.

1.	Using a screwdriver or remover, remove the crash pad side cover (A).

2.	Using a screwdriver or remover, remove the fuse box cover (A).

3.	After loosening the mounting screws, then remove the crash pad lower panel (A).

4.	Disconnect the diagnosis connector (A) and connector (B).

5.	After loosening the mounting screws, then remove the crash pad garnish [LH] (A).

6.	After loosening the mounting screws, then remove the cluster fascia panel (A).

7.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Cluster Fascia Panel Components and Components Location

Component Location 1. Cluster fascia panel ...

Center Fascia Panel Components and Components Location

Component Location 1. Center fascia panel ...

See also:

Use high quality ethylene glycol coolant
Your vehicle is delivered with high quality ethylene glycol coolant in the cooling system. It is the only type of coolant that should be used because it helps prevent corrosion in the cooling system ...

Components and Components Location
Component Location Index Engine Room 1. Receiver Drier2. Condenser3. Service Port (High Pressure)4. Service Port (Low Pressure)5. APT6. Compressor7. Expansion Valve Interior ...

Repair procedures
Inspection Front Door Lock Actuator Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2. Remove the front door module. 3. Disconnect the 7P connector from the ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com