Repair procedures
Inspection (With GDS)
1.
Check BCM input/output specification of multifunction switch
using the GDS. If the specification is abnormal, replace the lamp or
wiper switch.
2.
If diagnosis is ...
Mode Control Actuator Repair procedures
Inspection
1.
Ignition "OFF”
2.
Disconnect the connector of mode control actuator.
3.
Verify that the mode control actuator operates to the defrost
mode when connecting 12V to the termin ...
Engine Cover Repair procedures
Removal and Installation
1.
Remove the engine cover (A).
•
Lift up the lower end of engine cover, then left and right alternately.
•
When installing, confirm that t ...