Hyundai Azera: Timing System
- Drive Belt Components and Components Location
- Drive Belt Repair procedures
- Idler Components and Components Location
- Idler Repair procedures
- Drive Belt Tensioner Components and Components Location
- Drive Belt Tensioner Repair procedures
- Crankshaft Damper Pulley Components and Components Location
- Crankshaft Damper Pulley Repair procedures
- Front Oil Seal Components and Components Location
- Front Oil Seal Repair procedures
- Timing Chain Cover Components and Components Location
- Timing Chain Cover Repair procedures
- Timing Chain Components and Components Location
- Timing Chain Repair procedures
Engine Hanger Repair procedures
Removal and Installation
[Front engine hanger]
1.
Remove the front engine hanger (A)
Tightening torque:
44.1 ~ 53.6N.m (4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)
2.
Install in the reverse ord ...
Drive Belt Components and Components Location
Components
1. Drive belt
...
See also:
Body Control Module (BCM) Schematic Diagrams
BCM Connector Terminals
BCM(IPM) Input Signal SPEC
Signal NameOn/Off JudgmentInput CharacteristicsInput acquisition VBAT Threshold VoltageL_DRLOpt(NA)On : 3.2V UnderOff : 4.2V OverPull up(ON ...
Front Driveshaft Repair procedures
Replacement
1.
Loosen the wheel lug nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88. ...
Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refer t ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com