Removal and Installation |
1. |
Remove the drive belt.
(Refer to Timing System - "Drive Belt") |
2. |
Remove the drive belt idler (A).
|
3. |
Installation is reverse order of removal |
Camshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
•
DON'T remove the camshaft position se ...
Rear Hub - Carrier Repair procedures
Replacement
1.
Loosen the wheel lug nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from front hub.
Tightening torque:
88. ...
TPMS Receiver Description and Operation
Operation
1.
General Function
A.
Auto-locate/learn takes place only once per Ignition cycle.
B.
On successful completion, 4 road wheel sensor ID's, together
with their respective road whee ...