Hyundai Equus Manuals

Hyundai Azera: TPMS Receiver Description and Operation - Tire Pressure Monitoring System - Suspension System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: TPMS Receiver Description and Operation

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver Description and Operation

Operation
1.
General Function
A.
Auto-locate/learn takes place only once per Ignition cycle.
B.
On successful completion, 4 road wheel sensor ID's, together with their respective road wheel positions are latched into memory for monitoring.
C.
Until Auto-learn completes, previously learned sensors (together with their respective locations) are monitored for under inflation / leak warnings.
D.
Spare tire inflation / DTC state is not displayed.
2.
General Conditions to Learn New Sensors:
A.
Receiver must Auto-Locate 4 road sensors.
B.
Auto-location / learning only functions when speed is more than 20 kph (approx. 15 mph).
C.
Receiver must determine that it is confident that sensor is not temporary:
1)
Uses vehicle speed.
2)
Uses confidence reduction of previously learned sensors.
D.
Typical time at driving over 20 kph to learn a new sensor is up to 10 minutes.
3.
General Conditions to Un-Learn a sensor that is removed:
A.
It takes less than 10 minutes at 20~30kph.
B.
Confidence reduction is dependant on vehicle speed and the number of sensors known to the receiver.
TPMS Receiver Schematic Diagrams
Circuit Diagram Connector pin number Pin NO.DiscriptionRemark1IGN2CAN_Low3-4Battery5CAN_High6Ground ...

TPMS Receiver Repair procedures
Replacement     When the receiver first arrives for replacement: 1) It will be in Virgin State. 2) It will not be configured for any specific platform. 3) It will not ha ...

See also:

Repair procedures
Fuel Pressure Test 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)     When removing the fuel pum ...

Crankshaft Damper Pulley Repair procedures
Removal and Installation     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the conn ...

Exhaust Manifold Repair procedures
Removal and Installation [LH] 1. Disconnect the LH front and rear heated oxygen sensor (HO2S) connector. (Refer to Fuel System - "Heated Oxygen Sensor (HO2S)") 2. Remove the front muffler ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com