Hyundai Equus Manuals

Hyundai Azera: Camshaft Position Sensor (CMPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Camshaft Position Sensor (CMPS) Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures

Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
   
•
DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.
[Bank 1/Intake]

[Bank 1/Exhaust]

[Bank 2/Intake]

[Bank 2/Exhaust]

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Apply the engine oil to the O-ring.
   
•
Insert the sensor in the installation hole and be careful not to damage when installation.
   
•
Be careful not to damage the sensor housing and the connector.
•
Be careful not to damage the O-ring.
1.
Installation is reverse of removal.
Camshaft position sensor installation bolt:
6.9 ~ 9.8N.m (0.7 ~ 1.0kgf.m, 5.1 ~ 7.2lb-ft)
Camshaft Position Sensor (CMPS) Schematic Diagrams
Circuit Diagram ...

Knock Sensor (KS) Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. The two Knock Sensor (KS) are installed inside the V-valley of the cylinder bl ...

See also:

Injector Specifications
Specification ItemSpecificationCoil Resistance (?)0.98 ~ 1.14 [20°C(68°F)] ...

Glove Box Housing Repair procedures
Replacement     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Components and Components Location
Components 1. Steering column2. ECU3. Motor4. Steering gear box ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com