Hyundai Azera: Glove Box Housing Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

•	Put on gloves to protect your hands.

1.	Using a screwdriver or remover, remove the crash pad side cover (A).

2.	Disconnect the stopper (B) from the glove box (A).

3.	Disconnect the air damper (A) from the glove box (B).

4.	Disconnect the pin (A) and then remove the glove box (B).

5.	After loosening the mounting screws, then remove the passenger's under cover (A).

6.	Disconnect the connector (A).

7.	After loosening the mounting screws, then remove the glove box housing (A).

8.	Disconnect the connectors (A).

9.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Glove Box Housing Components and Components Location

Component Location 1. Glove box housing ...

Steering Column Shroud Panel Components and Components Location

Component Location 1. Steering column shroud panel ...

See also:

Front Oil Seal Components and Components Location
Components 1. Front oil seal ...

Components and Components Location
Components (1) 1. Parking brake pedal2. Parking brake cable3. Equalizer assembly Components (2) 1. Backing plate2. Operating lever3. Upper spring4. Lower spring5. Adjuster6. Shoe hold down ...

Front Body Body Repair
Front Body A Hood hinge mounting hole (O10)Fender panel mounting hole (O9)Front shock absorber mounting hole (O11)Cowl top cover mounting hole (O9)Roof panel front cornerFront pillar outer corne ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com