Hyundai Azera: Engine Hanger Repair procedures
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Hanger Repair procedures
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Hanger Repair procedures
| Removal and Installation |
| [Front engine hanger] |
| 1. |
Remove the front engine hanger (A)
|
| 2. |
Install in the reverse order of removal. |
| [Rear engine hanger] |
| 1. |
Remove the rear engine hanger (A)
|
| 2. |
Install in the reverse order of removal. |
Engine Hanger Components and Components Location
Components Location
...
Timing System
...
See also:
Front Stabilizer Bar Repair procedures
Replacement
1.
Remove the front wheel & tire (A).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
•
Be careful not to damage to the hub b ...
Oil Filter Body Repair procedures
Removal and Installation
1.
Remove the water pipe.
(Refer to Cooling System - "Water Pipe")
2.
Wait for 5 minutes after loosening the oil filter cap to drain well the oil in the oil filter.
...
1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution
caused by blow-by gases being emitted from the crankcase.
This system supplies fresh filtered air to the crankcase thro ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com