Hyundai Azera: Front Oil Seal Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Timing System / Front Oil Seal Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Timing System / Front Oil Seal Repair procedures
| Removal |
| 1. |
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley") |
| 2. |
Remove the front oil seal (A).
|
| Installation |
| 1. |
Using SST(09231-3C100), install timing chain cover oil seal.
|
| 2. |
Install the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley") |
Front Oil Seal Components and Components Location
Components
1. Front oil seal
...
Timing Chain Cover Components and Components Location
Components
1. Timing chain cover2. Gasket
...
See also:
Warnings and indicators (lnstrument cluster)
All warning lights are checked by turning the ignition switch ON (do not start
the engine). Any light that does not illuminate should be checked by an authorized
HYUNDAI dealer. After starting the e ...
Front Door Inside Handle Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
After loosening the mounting screws, then remove the front door inside handle (A).
3.
Installation ...
Rear Combination Lamp Repair procedures
Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A).
...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com