Hyundai Azera: Front Oil Seal Components and Components Location

Crankshaft Damper Pulley Repair procedures

Removal and Installation     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connecto ...

Front Oil Seal Repair procedures

Removal 1. Remove the crankshaft damper pulley. (Refer to Timing System - "Crankshaft Damper Pulley") 2. Remove the front oil seal (A). Installation 1. Using SST(09231-3C100), install t ...

See also:

Main Muffler Repair procedures
Removal and Installation 1. Disconnect the battery negative terminal. (Refer to Engine Electrical System - "Battery") 2. Remove the main muffler (A). Tightening torque: 39.2 ~ 58.8 N.m ( ...

Rear Assist Arm Repair procedures
Replacement 1. Remove the rear wheel & tire (A). Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     • Be careful not to damage to the hub bo ...

If engine turns over normally but does not start
1. Check fuel level. 2. With the ignition switch in the OFF position, check all connectors at the ignition coils and spark plugs. Reconnect any that may be disconnected or loose. 3. Check the fuel ...