Hyundai Azera: Hood
- Repair procedures
- Hood Assembly Components and Components Location
- Hood Assembly Repair procedures
- Hood Insulator Pad Repair procedures
- Hood Lift Repair procedures
- Hood Seal Weatherstrip Repair procedures
- Hood Weatherstrip Repair procedures
- Hood Latch Release Handle Components and Components Location
- Hood Latch Release Handle Repair procedures
- Hood Latch Components and Components Location
- Hood Latch Repair procedures
Repair procedures
Replacement
•
Be careful not to damage the fender and body.
•
When removing the clips, use a clip remover.
1.
Remove the head lamps.
(Refer to Body Elect ...
Repair procedures
Adjustment
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left.
2.
Adjust the hood height by turning the hood overslam bumpers (C).
...
See also:
Output Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the battery and the battery ...
Compressor Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negati ...
Owner maintenance
The following lists are vehicle checks and inspections that should be performed
by the owner or an authorized HYUNDAI dealer at the frequencies indicated to help
ensure safe, dependable operation of ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com